50
Keyset Mode
This feature allows you to determine the mode and baud rate of the
optional CTI Module connected to your phone. This setting is
stored in back-up memory in the case of a power outage or system
reset. When telephone is set to AT command mode, these AT
commands are supported.
Mode
Inactive
No CTI information is sent/received by the telephone.
ATD
Modem Dialing Command -- The telephone will recognize
the ATD and accept digits after the command.
ATH or
Modem On-Hook/Off-Hook Command -- ATH or ATH0 will
ATHX
force the telephone to go to the on-hook state from its
(X= 0 or 1)
current state. ATH1 will force the telephone to go to the off-
hook state from it's current state.
CKTU
Command used with Wanderer (a cordless key telephone
unit). The baud rate is not used in this mode; no change is
necessary.
PC Phone
CTI information used with Discovery Desktop and Discovery
PCPhone software must be set to 4800 baud rate.
SPI
Service Provider Interface -- Command used with TAPI
applications such as Discovery Link
Description
Keyset Mode