Advertisement
4. All personnel commissioned to work on or with the device must have read this instruction ma-
Caution
nual, and particularly the safety instructions chapter, before starting work. This applies especially
for personnel who only work with the device occasionally.
5. Stop the device immediately should you notice changes to the device or its operating behaviour
that are relevant to its safety. Have these remedied before restarting work.
6.
Do not carry out any modifications, additions or conversions to the device! This also applies to
Important
the installation and adjustment of safety equipment.
7. Spare parts must meet the technical requirements specified by the manufacturer. This can only
be guaranteed with original joke spare parts.
8. Any work on/with the device may only be carried out by qualified, appropriately trained and au-
thorised personnel. Pay attention to minimum statutory age limits!
9. Wear safety goggles when working with the belt grinder.
Caution
10. Personnel undergoing training or in a general apprenticeship should only be allowed to work
with the machine under the constant s-pervision of an experienced operator!
11. Restrain from any type of work that could jeopardise your safety.
12. The device may only be used if all protective and safety equipment is in place and in proper
working order.
13. Do not leave the device unattended when switched on!!
14. Stop and secure the device immediately in the event of malfunctions! Faults must remedied at
once.
4
Warranty/identification
Joke Technology GmbH warrant the correct manufacture of every joke product which is delivered in
accordance with the terms of contract and delivery.
This warranty does not cover damages caused by normal wear and tear, incorrect handling, negli-
gent use, the fitting of non-original spare parts, inadequate care and/or a failure to comply with this
technical manual.
The device may only be used by appropriately trained personnel. If it is not, all warranty claims will
Important
be forfeited according to the terms of delivery.
Device identification
The manufacturer's code and type code, CE label and series number can be found on the rear of the
control units or in the case of the handpieces on the handle sleeve.
Disposal
This product shall not be treated as household waste. Instead it shall
be handed over to the applicable collection point for the recycling of
electrical and electonic equipment.
02
Advertisement
