Synchronization; Using The Delta 44 With Your Software Application - M-Audio Digital Recording Interface Delta 44 Instruction Manual

Digital recording interface
Hide thumbs Also See for Digital Recording Interface Delta 44:
Table of Contents

Advertisement

Synchronization

For proper operation, the entire Delta 44 system is always synchronized to a single
master clock. This master clock is derived from the internal crystal oscillators.
When a WAV file is played through the Delta drivers, the software application
playing the WAV file is responsible for setting the sample rate in the sound card
hardware. The Delta 44 supports these sample rates by using either of its internal
crystal oscillators and dividing the rate of that oscillator by some value to derive the
proper sample rate.

Using the Delta 44 with your Software Application

Once the Delta 44's hardware and driver software are properly installed, it is ready
for use with your music application software. Some of these applications may
require you to highlight or enable the Delta 44 drivers within the program, and others
may have a utility that analyzes or profiles the audio cards in your system and
enables the drivers. Your software should have an audio device driver setup page.
WINDOWS MME AUDIO INPUT DEVICES: The Delta 44 analog inputs may be
used simultaneously for a total of 4 input channels.
application(s), the names of the Delta 44 audio input devices are:
PCM In 1/2 Delta-44
PCM In 3/4 Delta-44
Mon.Mixer Delta-44
The PCM In devices allow recording a stereo stream directly from the specified
analog input pairs. The Mon.Mixer device allows stereo recording from the digital
"monitor" mixer built-into the Delta 44. The audio data recorded from this device
is the mix of input and output streams set up in the Delta Control Panel software (see
"Delta 44 Control Panel Software" section).
Note that the input devices are stereo. Your application software
may break these down further to "left" and "right" mono devices.
Therefore you may see them as "Left PCM In 1/2 Delta-44, Right
PCM In 1/2 Delta-44", "Left PCM In 3/4Delta-44, Right PCM In 3/4
Delta-44", or "Left Mon.Mixer Delta-44, Right Mon.Mixer Delta-44,"
from within your recording software.
WINDOWS MME AUDIO OUTPUT DEVICES: The Delta 44 analog outputs may
all be used simultaneously for a total of 4 output channels. Within your software
application(s), the names of the Delta 44 audio output devices are:
WavOut 1/2 Delta-44
WavOut 3/4 Delta-44
Each WavOut device allows playing a stereo audio stream to the analog hardware
outputs, and into the hardware router or mixer. Your application software may break
12
Within your software

Advertisement

Table of Contents
loading

Table of Contents