Table of Contents
Advertisement
Drying cycle complete / removing laundry
Once the drying cycle is complete, the LED
Anti-crease/End is on as well as warning
LED's: Filter and Tank. If the Buzzer button
has been pressed, an acoustic signal sounds
intermittently for about one minute. Remove the
laundry:
1. Open door.
2. Remove visible fluff from the fluff filters. It
is best to use a damp hand for this pur-
pose. (see chapter: Maintenance and
cleaning)
3. Remove laundry.
Cleaning and maintenance
Cleaning fluff filters
The filters collect all the fluff which accumu-
lates during drying. To ensure that the dryer
works perfectly, the fluff filters (fine filters and
fluff filters) must be cleaned after each drying
cycle.
Caution! Never operate the dryer without
fluff filters or with damaged or blocked
fluff filters.
10
4. Turn the programme selector to
Important! after each drying cycle:
- clean the fluff filters
- drain the water reservoir
(see chapter: Maintenance and cleaning)
5. Close the door.
The drying cycles are automatically fol-
lowed by an anti-crease phase which lasts
around 30 minutes. The drum rotates at inter-
vals during this phase to protect the laundry
from creases. The laundry can be removed at
any time during the anti-crease phase.
II
I
2
3
5
6
Clean the door seal
Wipe the door seal with a damp cloth immedi-
ately after the drying cycle has finished.
Emptying the water reservoir
Empty the water reservoir after every drying cy-
cle.
off.
1
I
4
7
II
www.zanussi.com
Hide quick links:
Advertisement
Table of Contents
