Important Notes - Ledj LEDJ186 User Manual

Included IR remote functions:
Button functions:
01 - Blackout
02 - To set the brightness of the LED either
select 20%, 50% or 100% or alternatively
you can use the '+' and '-' buttons
03 - Flash off
04 - To set the flash speed of the LED either
select 20%, 50% or 100% or alternatively
you can use the '+' and '-' buttons
05 - Sets the LED fixture into DMX mode
06 - Sets the LED fixture into sound active mode
07 - Sets the LED fixture into slave mode
08 - Sets the DMX address for the LED fixture
DMX address examples:
To set the DMX address;
• Press the "S" button, the LED fixture will illuminate
in full, you can now start to set the DMX address
• Select the required 3 digit DMX address
(eg 001 or 136 or 275) the unit will then flash
to confirm the address has been set
• Now press the "DMX MODE" button to save the new address into the memory

Important notes:

• Set the DMX address on each fixture before plugging into the DMX controller
• The IR remote cannot be used when the fixture(s) are being controlled with a DMX controller
• The maximum IR transmitter distance is 10m - Please make sure that you have the IR remote
aimed directly at the front panel of each fixture to be programmed
• If you do not press the "DMX MODE" button after you have changed the DMX address when you
power down the fixture it will lose the address you have set
Setting the DMX address:
The DMX mode enables the use of a universal DMX controller. Each fixture requires a "start address"
from 1- 512. A fixture requiring one or more channels for control begins to read the data on the channel
indicated by the start address. For example, a fixture that occupies or uses 7 channels of DMX and was
addressed to start on DMX channel 100, would read data from channels: 100,101,102,103,104,105
and 106. Choose a start address so that the channels used do not overlap. E.g. the next unit in the
chain starts at 107.
www.prolight.co.uk
Operating instructions & DMX setup
02
01
04
03
OFF
06
OFF
05
DMX MODE SOUND ACTIVE
D
1 2 3
4 5 6 0
7 8 9
UV 50W COB Flood User Manual
DIMMING
20% 50% 100%
STROBE
20% 50% 100%
SLAVE SET ADDR
SA SL
S
+
_
07
08
Included
IR remote
Order code:
LEDJ90E
6