Travel system with seat unit, infant carrier, hood and raincover (14 pages)
Summary of Contents for My Child Nimbus
Page 1
Nimbus Stroller This product is tested to: BS EN 1888:2012 Suitable for children from: BIRTH up to 15kg INSTRUCTIONS: Please read carefully and keep for future reference. Your child’s safety may be affected if you do not follow these instructions...
Safety instructions Important: Read, understand and follow these instructions carefully and retain for future reference WARNING: To avoid injury ensure that your child is kept away when unfolding and folding this product. WARNING: Do not let your child play with this product. WARNING: It may be dangerous to leave your child unattended.
0161 335 2508. Welcome Thank you for purchasing the MyChild Nimbus Stroller Please read the instructions and warnings carefully before use to ensure safe and satisfactory operation of this product.
Parts checklist Contained in your carton are: Part Chassis Front wheels Hood Harness pads* Basket* Raincover These are pre-fitted but are removable page 3...
Opening the pushchair 1. Release the folding lock by lifting the 2. Raise both handles as far as they will lock off the peg (A). 3. DO NOT try and open the pushchair by forcing the handles apart. Place your foot on the frame ‘LOCK’...
Front wheel assembly 1. Align the front wheel assembly with the front axle. Push each wheel assembly firmly on until they click into place. Pull the front wheel to make sure it is attached. click NOTE: Check the wheel to make sure it is secure by pulling it.
Using the brakes WARNING: The brakes MUST always be ON when making adjustments, e.g. taking the child out, putting the child in or letting go of the handlebars. 1. Press down on either of the brake levers 2. Pull either of the brake levers up with with your foot to apply the brake.
Page 9
Adjusting the shoulder harness position 1. The rear seat unit is suitable from birth. There are 3 pairs of shoulder harness height positions (A1, 2 & 3), two pairs of waist harness positions (B1 & 2) and two crotch strap positions (C1 & 2). Select the harness positions that will allow you to adjust the harness appropriately to suit your child’s age and size.
Page 10
Adjusting the waist harness position To adjust the waist harness you will need to undo the webbing from the frame, pass it through the seat, reposition it and reattach the webbing. 1. Locate the split ring (A) for the waist harness at the back of the seat. 2.
Adjusting the crotch strap position Underneath seat Top of seat Top of seat 1. The crotch strap can be adjusted by locating the buckle underneath the seat unit (A). 2. Thread the buckle through the button hole (B). Thread the buckle back through so it is underneath the seat unit.
Page 12
Adjusting the calfrest ATTENTION: Ensure that the calfrest is ATTENTION: When the calfrest is up, it folded down when the child is getting allows the child to lie in a more horizontal in and out of the stroller. Failure to do so position when resting or sleeping.
Attaching/Using/Removing the hood (continued) 3. To open: Pull the front of the hood 4. To remove: Unfasten the hood’s Velcro forwards, then press down on the hinges tabs. Pull the clip off sideways as shown. (D) to lock the hood open. To close: Lift the hinges and fold the hood back.
Folding the pushchair WARNING! Fold the hood back before attempting to fold the pushchair. Failure to do so may damage the hood. 1. Turn handle (A) to the left as shown. 2. Pull the handle upwards (B) and begin to fold the pushchair forwards. 3.
Need help?
Do you have a question about the Nimbus and is the answer not in the manual?
Questions and answers