Homelink Wireless Control System; Programming A New Homelink - Mitsubishi 2016 OUTLANDER Owner's Handbook Manual

Programming a new HomeLink

To program HomeLink to operate a garage door, gate, or entry door opener, home or office lighting, you need to
®
be at the same location as the device.
1. Press the HomeLink button that you would like to program. The indicator light (A) will flash orange slowly.
®
2. Position the end of your hand-held transmitter (B) 1 to 3 inches (2 to 8 cm) away from the HomeLink
while keeping the indicator light in view.
3. Press and hold the hand-held transmitter button while watching the indicator light (A). Continue pressing the
button until the indicator light (A) changes from slowly flashing orange to either rapidly flashing green (rolling
code) or continuously lit green (fixed code). Now you may release the hand-held transmitter button.
4. Press the just-trained HomeLink
• If the indicator light stays on constantly green, programming is complete and your device should operate
when the HomeLink button is pressed and released.
®
• If the indicator light rapidly flashes green, firmly press, hold for 2 seconds and release the programmed
HomeLink button. Repeat the "press/hold/release" sequence a second time, and, depending on the
®
brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time
to complete the programming process. At this point if your device operates, programming is complete.
• If the device does not operate, continue with "Programming a new HomeLink
the programming of a rolling code equipped device.
5. At the garage door opener receiver (motor-head unit) in the garage, locate the "Learn" or "Smart" button. This
can usually be found where the hanging antenna wire is attached to the motor-head unit (see the garage door
opener manual to identify the "Learn" button.
6. Firmly press and release the "Learn" or "Smart" button. (The name and color of the button may vary by
manufacturer.) There are typically 30 seconds to initiate step 7.
7. Return to the vehicle and firmly press, hold for 2 seconds and release the programmed HomeLink® button.
Repeat the "press/hold/release" sequence a second time, and, depending on the brand of the garage
door opener (or other rolling code equipped device), repeat this sequence a third time to complete the
programming process. HomeLink® should now activate your rolling code equipped device.
NOTE: Some hand-held transmitters may actually train better a distance of 6 to 12 inches (15 to 20 cm). Keep
this in mind if you have difficulty with the programming process.
®
® button and observe the indicator light.
HOMELINK WIRELESS CONTROL SYSTEM (IF SO EQUIPPED)
®
button
®
" steps 5 to 7 to complete
®
1- HomeLink button 1
®
2- HomeLink button 2
®
3- HomeLink button 3
®
11