Craftsman 580.754910 Operator's Manual page 8

.
Place accessory tray (A) over holes (B) on handle
(viewing from front of unit). Push the tree clips
(C) into the holes until they sit flat against the
accessory tray.
/
5. Insert multi-colored quick connect spray tips and
other supplied accessories in spaces provided in
accessory tray. See How to Use Accessory Tray.
6. Attach bottle bracket (D) to handle with carriage
bolt (E) and black plastic knob (F). Tighten by
hand.
Project Pro@ Perfect IVlix
TM
Soap System
The pressure washer is equipped with a detergent
siphoning hose.
Attach Project Pro® Perfect IVlix
TM
Siphon
to Pump
Attach the tube end of the blue Perfect Mix
TM
Siphon
(G) to the barbed tube fitting (H) on the pump.
Attach Perfect IVlix
TM
Detergent Siphon to
Concentrate Bottle
Place Perfect Mix
TM
bottle (not included) in the wire-
form bracket on the handle. Remove cap from bottle
and insert the Perfect Mix
TM
Siphon (J). Screw the
siphon unit to the top of the bottle (K). Use the clip on
the cap (J) to snap siphon to wire form bracket when
siphon is not in a concentrate bottle.
Add Engine Oil
1. Place pressure washer on a flat, level surface.
2. Clean area around oil fill and remove oil fill cap/
dipstick.
/ OiL FILLER CAP/DIPSTICK
UPPER
_ -,9_ LIMIT
r_ _ LOWER
LiMiT
3. Using oil funnel (optional), slowly pour contents of
supplied oil into oil fill opening, frequently checking
oil level. DO NOT OVERFILL.
NOTICE Improper treatment of pressure washer
could damage it and shorten its life.
o DO NOT attempt to crank or start the engine before it has
been properly serviced with the recommended oil. This
could result in an engine failure.
4. Replace oil fill cap/dipstick and fully tighten.