Light Switch; Hour Meter - Toro Workman MD Operator's Manual

Choke Control
The choke control is located below and to the right of the
operator's seat. Use the choke to help start a cold engine
by pulling the choke control outward
engine starts, adjust the choke to keep the engine running
smoothly. As the engine warms up, push in the choke control
to the Off position.
1. Choke control
Gear-shift Selector
The gear shift selector is located between the seats and below
the parking brake lever. The gear shift selector has three
positions: Forward, Reverse, and Neutral
Note: The engine will start and run in any of the three
positions.
Important: Always stop the vehicle before changing
gears.
Horn Button (Models 07266TC and
07273TC)
The horn button is located at the lower left corner of the dash
panel (Figure 7). Press the horn button to sound the horn.
(Figure 6). After the
Figure 6
2. Gear-shift selector
(Figure 6).
1. Horn Button (Models
07266TC and 07273TC)

2. Hour meter

3. Light switch

Light Switch
The light switch is located to the left of the steering column
(Figure 7). Use the light switch to illuminate the headlights.
Push up the light switch turn on the headlights or push down
the switch to turn off the lights.
Hour Meter
The hour meter is located to the left of the light switch
(Figure 7). Use the hour meter to find out the total number of
hours the engine has run. The hour meter starts to function
whenever you turn the key switch to the On position or if
the engine is running.
Engine Oil Pressure Light
The engine oil pressure light is located to the right of the
steering column (Figure
if the engine oil pressure drops below a safe level to operate
the engine. If the light comes on and remains lit, shut off the
engine and check the engine oil level. Add oil to the engine if
necessary; refer to Checking the Engine-Oil Level (page
Note: The oil light may flicker, this is normal and no action
needs to be taken.
14
Figure 7
4. Oil light
5. Power point
6. On/Off switch
7). The oil light warns the operator
19).