Maintenance; Recommended Maintenance Schedule(S) - Toro Workman MD Operator's Manual

Maintenance

Note: Looking for an Electrical Schematic for your machine? Download a free copy of the schematic by visiting www.Toro.com
and searching for your machine from the Manuals link on the home page.
Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 25 hours
After the first 50 hours
After the first 100 hours
After the first 200 hours
Before each use or daily
Every 100 hours
Every 200 hours
Every 400 hours
Every 800 hours
Every 1,000 hours
Yearly
Important: Refer to your engine owner's manual for additional maintenance procedures.
Maintenance Procedure
• Check the condition of the drive belt.
• Check the tension of the starter-generator belt.
• Change the engine oil.
• Change the oil filter (Models 07273 and 07273TC).
• Check the air filter for the carbon canister.
• Replace the carbon canister filter.
• Perform the breaking in a new machine guidelines.
• Replace the air filter element.
• Preform the pre-staring checks. Check the following items each time you begin
using the machine for the day:
• Check the brake-fluid level.
• Check the engine oil level.
• Check the tire pressure.
• Check gear-shift operation.
• Grease the bearings and bushings.
• Check the air filter. Replace the air filter element sooner if it dirty or damaged.
• Change the engine oil.
• Change the oil filter (Models 07273 and 07273TC).
• Check the spark plug.
• Check the condition of the tires and rims.
• Torque the wheel-lug nuts.
• Check the front wheel toe-in and camber.
• Check the transaxle oil level.
• Check the operation of the Neutral gear shift position.
• Clean the engine cooling areas.
• Inspect the brakes.
• Check the air filter for the carbon canister.
• Replace the carbon canister filter.
• Adjust the parking brake if needed.
• Check the condition and tension of the drive belt.
• Check the tension of the starter-generator belt.
• Inspect the fuel lines and connections.
• Clean the primary-drive clutch.
• Replace the fuel filter.
• Change the transaxle fluid.
• Change the brake fluid.
• Complete all of the yearly maintenance procedures that are specified in the engine
owner's manual.
25