Advertisement
11
Assemble the wing to the fuselage and insert the other side
main wing to the fuselage via main wing joiner as illustration.
12
Fix the wing to fuselage with screws throught the holes
applied in the wings and fuselage.
Screw
Washer
Screw (6x35mm)
Washer (6x12mm)
Accessory list for the coming installation steps.
Stabilizer
joiner (12x297mm)
Pivot&round hinge(4.5X67mm)
Screw (3x16mm)
Rod (2x300mm)
Washer(2x6mm)
Screw (2x10mm)
2
TP Screw (2.3x12mm)
Collar (2mm)
8
Nut (2mm )
Washer(3x6mm)
2
Clevis
Control horn
2
13
Apply instant type AB glue to appropriate position of the elevator and
pivot & round hinges. Insert the pivot & round hinges to the elevator.
Pivot & round hinges(4.5x67mm)
6
Make sure hinges are
mounted in the same line.
14
Keep about 1mm width space between the elevators
and the stabilizers.
Trailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Elevator
1mm
2
Make sure they are in
2
the right position while
installing.
15
Assemble the elevators to the stabilizers via pivot & round hinges.
1
6
2
2
2
2
2
2
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
6
16
Assemble the stabilizer to the fuselage through the tail joint.
17
Connect the control horn and the clevis via the linkage.
Collar
Nut
Washer 2x6mm
Screw 2x10mm
18
Epoxy the control horn to the slots in the elevator,assemble the
elevator servo to the fuselage as illustration.
19
Fix the stabilizers to the tail fuselage via screws.
Washer(3x6mm)
2
Screw (3x16mm)
2
Screw
Washer
Accessory list for the coming installation steps.
Collar (3mm)
Screw (2x10mm)
4
Nut (2mm )
Washer(2x6mm)
4
Aluminum tube
1
Clevis
4
Control horn
Tail wheel (45mm)
TP Screw (2.3x12mm)
1
Steel wire (0.5x3000mm)
Tail landing gear 3mm
Pivot&round hinge(4.5X67mm)
Copper joiner
20
Install the tail landing gear.
Collar
Collar
Collar
7
3
4
4
2
3
2
1
3
4
Advertisement
