Advertisement
21
According to the illustration below bend the tail landing
gear wire and cut off the surplus part.
25mm
45mm
22
Trim a slot and drill a hole in the rudder for helping
assemble the tail landing to it.
3mm
25mm
23
Epoxy the pivot & round hinges to the rudder,drill holes to appropriate
position in the rudder and assemble the tail landing gear to it as shown.
Make sure hinges are
mounted in the same line.
24
Keep some space about 1mm width between the rudder
and tail edge.
Trailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Rudder
1mm
Make sure they are in
the right position while
installing.
25
Epoxy the rudder to the vertical fin..
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
26
Assemble the tail landing gear to tail fuselage as below.
TP Screw (2.3x12mm)
8
6
Apply instant type AB glue to the control horn and the slots in
the aileron, insert the control horn to the slots as illustration.
Accessory list for the coming installation steps.
wing joiner (25x700mm)
1
Screw (6x35mm)
2
Washer (6x12mm)
2
TP Screw (3x20mm)
8
Wheel(100mm)
2
Lock Nut(4mm )
2
7
Assemble the wheel to the retracts.
Lock Nut(4mm )
Wheel(100mm)
8
Assemble the retract.
TP Screw (3x20mm)
8
9
The standard sketch map when the kit install completion.
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
Temporarily fasten down the main wing and
check its correct position.
A = A '
B = B '
10
Insert the main wing joiner to one side of the lower wing.
Main wing joiner (25x700mm)
1
Main wing joiner (16x499mm)
5
Advertisement
