Advertisement
6
(with 8 servos),
6
6 channel radio for aiplane is highly recommended for this model.
6
: 4-cycle .120
2.5 in Spinner
"
15
X7
Warning
Remove the covering with proper
pressure to cut through only the covering itself.Otherwise,
cutting down into the balsa structure may weaken the
model part and cause accident.
The pre-covered film on ARF kits may wrinkle due to
variations of temperature.Smooth out as explained right.
Pre-cover the covering with clean cloth!
Start at low setting. Increase the setting if
necessary.If it is too high,you may damage
the film.
Iow setting
with cover(cloth)
48
Install the wheel to the fixed landing gear.
Collar (5mm)
TP Screw (2.3x12mm)
Collar 5mm
2
Wooden supporter
TP Screw (2.3x12mm)
8
Landing gear straps
4
49
Epoxy the fixed landing gear to the main wing.
50
Adjustment of the aileron and flap,be sure they can work
perfectly.
AILERON
45mm
45mm
AILERON
AILERON
51
Adjustment of the rudder, be sure it can work perfectly.
RUDDER
Side View
Top view
42mm
42mm
52
Adjustment of the elevator,be sure it can work perfectly.
ELEVATOR
Top view
40mm
40mm
Position for
right diagram.
53
Centre of the Gravity.
137mm
137mm
13
Advertisement
