Advertisement
Accessory list for the coming installation steps.
Rod (2.5x300mm)
2
TP Screw (2.3x12mm)
8
Servo tray(70x58x2mm)
2
Pivot&round hinge(4.5X67mm)
8
Collar (2.5mm)
2
Screw (3x16mm)
2
Nut (3mm )
2
Clevis
2
Aluminum Washer (3x6mm )
2
Control horn
2
1
Apply instant type AB glue to appropriate position of the aileron and
pivot & round hinges. Insert the pivot & round hinges to the ailerons.
pivot & round hinges(4.5x67mm)
8
Make sure hinges are
mounted in the same line.
2
Keep about 1mm width space between the aileron and
the trailing edge.
Trailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Aileron
1mm
Make sure they are in
the right position while
installing.
3
Apply instant type AB glue to appropriate position in the
trailing edge and assemble the ailerons to them.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
4
Install the aileron servo to the servo mount as illustration
below.
5
Install the control horn and connect the linkage.
Collar
Nut
Clevis
Washer 3x6mm
Screw 3x16mm
4
27
Epoxy the control horns to the slots in the rudder.
28
Lock the linkage to the control horn with screws and nuts
as below.
Screw (2x16mm)
Clevis
Aluminum tube
Copper joiner
S t e e l w i r e
29
Install the servo of the rudder.
Washer(2x5mm)
Screw (2x10mm)
Clevis
Lock Nut (2mm )
Copper joiner
S t e e l w i r e
Clevis
Copper joiner
Screw (2x10mm)
Nut (2mm )
Washer(2x6mm)
30
Assemble the servo of the rudder in the fuselage and
connect the servo and the rudder via steel wires.
31
The sketch map of how the steel wires works for the
rudder.
32
The sketch map should be when the rudder and stabilizer
install completion.
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
Temporarily fasten down the main wing and
check its correct position.
A
A '
2
2
2
2
2
B '
B
9
A = A '
B = B '
Advertisement
