Sharp PN-C703B Operation Manual page 25

■ AUDIO
AUDIO SETTINGS
Set by the currently selected picture mode.
TREBLE
Adjusts the volume of treble-level sound.
BASS
Adjusts the volume of bass-level sound.
BALANCE
Adjusts the balance of the audio sound between right and left.
RESET
Resets the values of the AUDIO menu items of the currently selected picture mode to the factory default settings.
■ ECOLOGY
STANDBY MODE
When STANDARD is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed
in standby mode.
When LOW POWER is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the
startup time from standby mode becomes longer.
OFF IF NO SIGNAL
Determines whether or not the monitor will go into standby mode when a video signal is not received for 15 minutes. When
5 minutes remain until switching to standby mode, the remaining time will be shown by minute. The default setting for this
function is DISABLE. If this function is set to ENABLE the monitor will go into standby mode 15 minutes after a connected PC
goes into sleep mode. Monitor power will not be restored automatically when the connected PC wakes up. The user will need
to use the remote control unit to manually restore power to the monitor.
OFF IF NO OPERATION
Determines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit,
or RS-232C command operations for a certain period of time.
30MIN.......... Switch to standby mode when the monitor is left idle for 30 minutes.
4HR ............. Switch to standby mode when the monitor is left idle for 4 hours.
DISABLE ..... This function is not used.
When 5 minutes remain until switching to standby mode, the remaining time will be shown by minute.
■ SETUP
HDMI AUTO WIDE
Set whether the picture size is automatically selected based on the signal received from the device that is connected to HDMI.
HDMI CEC LINK
When ON is selected, HDMI CEC LINK is enabled, and when operation starts on an external device, the monitor power
automatically turns on and input switches to the connected HDMI input terminal. The power of the external device also turns
off based on operation of the monitor. But operation by RS-232C command is not linked to this operation. In case of the
unintended movement, select OFF.
LANGUAGE
Sets the display language for the menu screen.
SOFTWARE VERSION
You can check the current version of the software.
ALL RESET
Resets all the settings to the factory default settings. If the video is distorted after this is executed, turn off the power with the
POWER button on the monitor, and then disconnect and reconnect the power cord.
Menu Items
25
E