Transporting Your Motorcycle - Honda CRF250R Owner's Manual

Transporting Your Motorcycle

Transporting Your Motorcycle

If you use a truck or motorcycle trailer to transport
your Honda, we recommend that you follow these
guidelines:
• Use a loading ramp.
• Relieve the fuel pressure (page 40) and drain
the fuel from the fuel tank into an approved
petrol container.
• Secure the motorcycle in an upright position,
using motorcycle tie-down straps. Avoid using
rope, which can loosen and allow the
motorcycle to fall over.
144
Tips
To secure your CRF, brace the front wheel against
the front of the truck bed or trailer rail.
Attach the lower ends of two straps to the tie-down
hooks on truck bed or trailer rail. Attach the upper
ends of the straps to the handlebar (one on the right
side, the other on the left), close to the fork.
Check that the tie-down straps do not contact any
control cables or electrical wiring.
Tighten both straps until the front suspension is
compressed about half-way. Too much pressure is
unnecessary and could damage the fork seals.
Use another tie-down strap to keep the rear of the
motorcycle from moving.
We recommend that you do not transport your
CRF on its side. This can damage the motorcycle,
and leaking petrol could be a hazard.