Canon PIXMA iP6220D Service Manual page 11

absorber is almost
full.
Press [OK] to
continue but early
replacement
recommended. <See
manual>
Incompatible device
detected.
Remove the device.
The following ink
may have run out.
U161
An ink cartridge that
was once empty is
installed.
U162
Auto head align has
failed. Press [OK] and
repeat operation.
<See manual>
Cover is open.
*1: The main waste ink absorber is separate from the platen waste ink absorber. In servicing, replace the waste ink
absorber which becomes full.
[See Section 3-3. Adjustment / Settings, (6) Service mode, for details.]
ink absorber becomes
almost full.
[1700 for the main
waste ink absorber,
1710 for the platen
waste ink absorber]
- The connected digital
camera or digital video
camera does not
support Camera Direct
Printing. [2001]
Remaining ink amount
-
unknown. [1685/1686]
Failed in automatic
-
print head alignment.
Front cover open.
-
[1200]
will clear the error, and
enable printing.
*1
At repair :
For main waste ink
absorber replacement,
replace
- the bottom case unit, or
- the ink absorber kit
For platen ink absorber
replacement,
replace
- the ink absorber , and
- the ink absorber kit
MP450: QY5-0151).
Remove the cable
between the camera and
the machine, press the
Stop/Reset button, then
re-connect the cable.
A once-used ink
cartridge (except the one
which has been used
until just before
replacement) is installed.
Replace the applicable
ink cartridge with a new
one, or press the OK
button.
Press the OK button to
exit the error, confirm
the following, then do
the print head alignment
again:
- Set A4 or LTR size
plain paper.
- If the ink nozzles are
clogged, cleaning the
ink cartridge.
- If the paper output slot
has been exposed to a
strong light, move the
printer to a darker
location.
Close the front cover.
1-5
indicating the waste ink
absorber is full, is likely to
occur soon.
Pressing the OK button will
exit the error without ink
cartridge replacement,
however, the function to
detect the remaining ink
amount is disabled.
Press the Stop/Reset button.
- If paper is being fed at
error occurrence, the error
is indicated after the paper
is ejected.
- If the error occurs, the print
head alignment values are
not changed.
- After exit from the error by
the Stop/Reset button, the
automatic print head
alignment will not be re-
done.