Object Reference Command Example - ZyXEL Communications UAG Series User Manual

Table 6 show reference Commands (continued)
COMMAND
show reference object-group username
[username]
show reference object-group address
[object_name]
show reference object-group service
[object_name]
show reference object-group interface
[object_name]
show reference object-group aaa ad
[group_name]
show reference object-group aaa ldap
[group_name]
show reference object-group aaa radius
[group_name]

3.1.1 Object Reference Command Example

This example shows how to check which configuration is using an address object named
LAN1_SUBNET. For the command output, firewall rule 3 named LAN1-to-UAG is using the address
object.
Router(config)# show reference object address LAN1_SUBNET
LAN1_SUBNET References:
Category
Rule Priority
Description
===========================================================================
Firewall
3
LAN1-to-UAG
Router(config)#
UAG CLI Reference Guide
DESCRIPTION
Displays which configuration settings reference the specified user group
object.
Displays which configuration settings reference the specified address
group object.
Displays which configuration settings reference the specified service
group object.
Displays which configuration settings reference the specified trunk object.
Displays which configuration settings reference the specified AAA AD
group object.
Displays which configuration settings reference the specified AAA LDAP
group object.
Displays which configuration settings reference the specified AAA RADIUS
group object.
Rule Name
N/A
Chapter 3 Object Reference
43