Table of Contents
Advertisement
C
HAP T ER
This chapter describes two features that controls the LEDs of the managed APs connected to
your NXC - Locator and Suppression.
16.1 LED Suppression Mode
The LED Suppression feature allows you to control how the LEDs of the AP behave after it's
ready. The deafult LED suppression setting of the AP is different depending on your AP
model.
When the AP is booting or performing firmware upgrade, the LEDs will lit
regardless of the setting in LED suppression.
16.2 LED Suppression Commands
Use these commands to set how you want the LEDs to behave after the device is ready. You
must use the configure terminal command before you can use these commands.
Table 54 LED Suppression Commands
COMMAND
led_suppress ap_mac_address enable
led_suppress ap_mac_address disable
show led_suppress ap_mac_address
status
NXC CLI Reference Guide
DESCRIPTION
Sets the LEDs of the specified AP to turn off after
it's ready.
Sets the LEDs of the specified AP to stay lit after
the NXC is ready.
Displays whether LED suppression mode is
enabled or disabled on the specified AP.
16
LEDs
119
Advertisement
Table of Contents
