Table of Contents
Advertisement
10.5 MAC Filter Profile Commands
The following table identifies the values required for many of these commands. Other input
values are discussed with the corresponding commands.
Table 38 Input Values for General MAC Filter Profile Commands
LABEL
macfilter_profile_name
description2
The following table describes the commands available for security profile management. You
must use the
can use these commands.
Table 39 Command Summary: MAC Filter Profile
COMMAND
show wlan-macfilter-profile {all |
macfilter_profile_name}
wlan-macfilter-profile rename
macfilter_profile_name1
macfilter_profile_name2
[no] wlan-macfilter-profile
macfilter_profile_name
filter-action {allow | deny}
[no] MAC description description2
exit
10.5.1 MAC Filter Profile Example
The following example creates a MAC filter profile with the name 'MACFILTER01'..
Router(config)# wlan-macfilter-profile MACFILTER01
Router(config-macfilter-profile)# filter-action deny
Router(config-macfilter-profile)# MAC 01:02:03:04:05:06
Router(config-macfilter-profile)# MAC 01:02:03:04:05:07
Router(config-macfilter-profile)# MAC 01:02:03:04:05:08
Router(config-macfilter-profile)# exit
Router(config)#
NXC CLI Reference Guide
DESCRIPTION
The MAC filter profile name. You may use 1-31 alphanumeric
characters, underscores (
cannot be a number. This value is case-sensitive.
Sets the description of the profile. You may use up to 60
alphanumeric characters, underscores (
is case-sensitive.
configure terminal
Chapter 10 Wireless LAN Profiles
), or dashes (-), but the first character
_
command to enter the configuration mode before you
DESCRIPTION
Displays the security profile(s).
all: Displays all profiles for the selected operating mode.
macfilter_profile_name: Displays the specified
profile for the selected operating mode.
Gives an existing security profile
(macfilter_profile_name1) a new name
(macfilter_profile_name2).
Enters configuration mode for the specified MAC filter
profile. Use the no parameter to remove the specified
profile.
Permits the wireless client with the MAC addresses in this
profile to connect to the network through the associated
SSID; select deny to block the wireless clients with the
specified MAC addresses.
The default is set to deny.
Sets the description of this profile. Enter up to 60
characters. Spaces and underscores allowed.
Exits configuration mode for this profile.
_
), or dashes (-). This value
description MAC01
description MAC02
description MAC03
99
Advertisement
Table of Contents
