Status Screen In Easy Mode - ZyXEL Communications NBG6515 User Manual

The following table describes the labels in this screen.
Table 23 Wireless Security: WPS
LABEL
Wireless
Security
WPS
Register
Exit

6.7 Status Screen in Easy Mode

In the Network Map screen, click Status to view read-only information about the NBG.
Figure 38 Status Screen in Easy Mode
The following table describes the labels in this screen.
Table 24 Status Screen in Easy Mode
ITEM
Name
Time
WAN IP
MAC Address
Firmware
Version
Chapter 6 Easy Mode
DESCRIPTION
Click this to go back to the Wireless Security screen.
Create a secure wireless network simply by pressing a button.
The NBG scans for a WPS-enabled device within the range and performs wireless security
information synchronization.
Note: After you click the WPS button on this screen, you have to press a similar button in the
wireless station utility within 2 minutes. To add the second wireless station, you have
to press these buttons on both device and the wireless station again after the first 2
minutes.
Create a secure wireless network simply by entering a wireless client's PIN (Personal
Identification Number) in the NBG's interface and pushing this button.
Type the same PIN number generated in the wireless station's utility. Then click Register to
associate to each other and perform the wireless security information synchronization.
Click Exit to close this screen.
DESCRIPTION
This is the name of the NBG in the network. You can change this in the Maintenance >
General screen in Section 25.3 on page
This is the current system date and time.
The date is in YYYY:MM:DD (Year-Month-Day) format. The time is in HH:MM:SS
(Hour:Minutes:Seconds) format.
This is the IP address of the WAN port.
This is the MAC address of the NBG.
This shows the firmware version of the NBG.
The firmware version format shows the trunk version, model code and release number.
NBG6515 User's Guide
160.
48