Table of Contents
Advertisement
AC power cord and
display cable
If you damage the AC
power cord or display
cable, it may result in fire or
electric shock.
• Do not pinch, bend, or
twist the cable
excessively. The core
lines may be bared and
cut, and cause short-
circuit, resulting in fire or
electric shock.
• Do not convert or damage the AC power cord or
display cable.
• Do not put anything heavy on the AC power cord
or display cable. Do not pull the AC power cord
or display cable.
• Keep the AC power cord or display cable away
from heat sources.
• Be sure to grasp the plug when disconnecting the
AC power cord.
Refer to the operating instructions when
disconnecting the display cable. If the AC power
cord or display cable is damaged, stop using it and
ask your dealer or Sony service center to exchange
it.
Not in use
For environmental
and safety reasons,
it is recommended
that the Plasma TV
is not left in standby
mode when not in
use. Disconnect from the AC power outlet.
Cable wiring
Take care not to catch your feet on the cables. It
may damage the Plasma TV.
Installation
Do not install optional components too close to
the display unit. Keep optional components at
least 30 cm away from the display unit. If a VCR
is installed in front or at the right side of the
display unit, the picture may distort.
Heat
Do not touch the surface of the display unit. It
remains hot, even for some time after the
display unit is turned off.
11
Safety Information
Advertisement
Table of Contents
