Table of Contents
Advertisement
On the PDP (Plasma Display Panel)
Please note that the PDP screen is made with high-precision technology. However, black points or
bright points of light (red, blue, or green) may appear constantly on the PDP screen, and irregular
colored stripes or brightness may appear on the PDP screen. This is not a malfunction.
On handling the remote control
• Handle the remote control with care. Do not drop or step on it, or spill liquid of any kind.
• Do not place the remote control in a location near heat source, or in a place subject to direct sunlight,
or in a damp room.
On handling and cleaning the screen surface of the display unit
The screen of this display unit has an anti-reflection screen coating. To avoid screen degradation,
follow the points mentioned below. Do not push on or scratch with hard objects, or throw anything at
the screen. The screen may be damaged.
• Be sure to unplug the AC power cord connected to the Plasma TV from the AC power outlet before
cleaning.
• Do not touch the display panel after operating continuously for a long period as the display panel
becomes hot.
• The screen of this display unit has an anti-reflection screen coating. We recommend not to touch
much of the screen surface.
• Clean the screen with the supplied cleaning cloth or a soft cloth lightly moistened with a mild
detergent solution.
• Never use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine. This
type of contact may result in damage to the screen surface.
On cleaning the cabinet
• Be sure to unplug the AC power cord connected to the Plasma TV from the AC power outlet before
cleaning.
• Clean the cabinet with the supplied cleaning cloth or a soft cloth lightly moistened with a mild
detergent solution.
• Note that material deterioration or screen coating degradation may occur if the display unit is
exposed to a volatile solvent, such as alcohol, thinner, benzine or insecticide, or if prolonged contact
is maintained with rubber or vinyl materials.
• The ventilation holes can accumulate dust over a period of time. The accumulate dust may make the
cooling function of the built-in fan less effective. To prevent this, we recommended removing the
dust periodically (once a month) using a vacuum cleaner.
Important Notice
When used at an altitude of greater than 2400m (7891 feet or air pressure less than 750hPa), this
Plasma Display Panel may generate a low buzzing sound as a result of the difference between
the interior and exterior air pressure of the panels. This is not considered a defect and is not
covered under by the Limited Warranty. This buzzing sound is the inherent characteristic of any
Plasma Display Panel.
13
Safety Information
Advertisement
Table of Contents
