Electrical Schematics - Sea Ray 190 Sport Owner's Manual

190 s
7. p
erManenTlY
b c
WireD aTTerY
If your boat is equipped with a permanently
installed, on-board, pre-wired battery charger, it
will be mounted to a bulkhead or component board
on the boat, and hard-wired to the battery. The
charger is designed for the marine environment
and is fully automatic. The charger's AC plug will
be either stowed next to it or routed to a bulkhead
feed through inlet depending on the boat model,
The inlet allows the plug to exit the compartment
and keeps the cord from being pinched by a hatch.
If the boat is not equipped with an inlet then the
hatch will need to be kept open or ajar to allow the
cord to exit without being pinched.
To use the on-board battery charger:
1. Plug an extension cord to the battery charger's
AC cord.
2. Secure and route the extension cord to keep it
from pulling at the ends and from being a trip
hazard.
3. Connect the other end of the extension cord to a
ground Fault Circuit Interrupt (gFCI) protected
receptacle.
Further use of this charger in regard to battery
maintenance is discussed in the Battery Maintenance
and the Long Term Battery Storage and Maintenance
Recommendations sections of this manual.
Refer to the owner's manual package for instructions
and warranty information.
24
e
®
porT
i p -
nsTalleD re
(
harger opTional
s
lecTrIcal
)
Never block air circulation through or around the unit.
Never store any gear on top of the unit.
Never modify the charger's plug in any way. Doing so
can create a shock hazard.
Avoid serious injury or death from fire, explosion, or
electrical shock.
• The battery charger must be connected to
Ground Fault Circuit Interrupt (GFCI) protected
receptacle.
* When using an extension cord, connect the AC
charger plug before connecting to the GFCI
protected receptacle.
• Make connection in an open atmosphere free of
explosive fumes.
• Make connection in a secure manner that will
avoid contact with water.
8. e
lecTrical
This owner's manual contains electrical schematics
and wiring harness illustrations for your boat. These
electrical schematics were generated by electrical
CAD designers at the engineering division for
technical reference and service technicians. Sea
Ray does not recommend that you attempt to work
®
on the boat's electrical system yourself. Instead,
we recommend that you take your boat to your
authorized Sea Ray
reserves the right to change or update the electrical
system on any model at any time without notice to
the consumer and is NOT obligated to make any
updates to units built prior to changes.
ysTem
! WARNING
! WARNING
! WARNING
s
cheMaTics
dealer for service. Sea Ray
® ®
190 Sport
®