Table of Contents
Advertisement
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the
battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
Do not cover the charger.
The appliance/battery must be placed in a well ventilated
area when charging.
The following symbols are found on your charger:
Your charger is double insulated; therefore no
earth wire is required.
Fail-safe isolating transformer. The mains supply is
electrically separated from the transformer output.
130
o
C
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charger must
be disconnected from the mains supply and taken
to an authorised service centre for repair.
The charger is intended for indoor use only.
Electrical safety
The charger is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
4
Features
This appliance includes some or all of the following features:
1. Flexible hook
2. LED light bar
3. Battery status LED
4. On/off/brightness switch
5. Charging socket
6. Mains charging adaptor
7. Charger jack plug
Use
Charging the light bar (fig. A)
Insert the charger jack plug (7) into the charging socket
(5).
Insert the mains charging adaptor (6) into a mains
power socket.
The red battery status LED (3) will light to show that the
battery is charging.
Do not charge for more than 40 hours.
Remove the mains charging adaptor (6) from the
charging socket (5).
After charging, wait for 5 minutes before using the light
bar.
Using the flexible hook (fig. B and C)
The flexible hook (1) may be used to store, support or
suspend the light bar.
The flexible hook allows the light bar to be set in any
position (fig. B).
Make sure that the flexible hook is secure around the
supporting object.
Operating the light bar
Press the on/off/brightness switch (4) once for the high
brightness setting.
Press the on/off/brightness switch (4) again for the low
brightness setting.
To turn the light bar off, press the on/off/brightness
switch (4) a third time.
Maintenance
Your Black & Decker corded/cordless appliance/tool
has been designed to operate over a long period of time
with a minimum of maintenance. Continuous
satisfactory operation depends upon proper appliance/
tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless appliances/tools.
Switch off and unplug the appliance/tool.
Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack
Advertisement
Table of Contents
