Honda GL1100 Interstate Owner's Manual page 57

Reverse the removal procedure, making sure
t h e s p lin e s (3 ) o n t h e fla nge t it into t he rinB
gear (4) on the final drive as you install
the
wheel.
Spread the pinch bolt slot (5) with a flat_btade
screwdrrver. Insert the axle, making sure
tt rs
lree to turn, then place a drift or scr€wdriver
into the left end of the axle to prevent it
from
turting. Torque the axle to 80_100 N.m (8.0_
I0.0 kg-m, 58-72 ftJb). Remove the screw-
ddvers or drift from the axle and pinch
bott
slor, and next torque the Iollowing bolts
in
this order:
l. Final drive gear case attaching nuts:
35-45 N.m
(3.5-4.5 kg-m, 25_j3 ft_lb)
2. Axle pinch bott:
24-29 N.m
(2.4-2.9 kg-m, l7_21 ft-lb)
3. Shock absorber bolt and nut:
30-40 N.m
(3.0-4.0 kg-m, 22-29 frlb)
CAUTION:
* When installing
the wheel,fit the brake disc
between the brake pads carefully.
Afle. installing the wheel, apply the
brake
several trmes and then check that the
ivheel
rotates freely when released. Recheck
the
wheel if the brake drags or if the wheer
ooes
ld .
)m
da
ul
tly
S2
Lns
.he
not rotate freely.
CAUTION:
* Alv,.ays replace
used corter pins with new
WARNING
* Ifa torque wrenchwas
not usedfor inslalla-
tion, see your dedler as soon as possible
to
rerd! ptoper assembly.
(5) Pinch bott stot
I