Attaching The Seat; Attaching The Chute Deflector - White Outdoor LT-17 686 Operator's Manual

Seat Pivot
Bracket
Seat
Stop
Tab
Figure 4
Seat
Spacers
Seat
Stop
Slot
Seat
Spacers
Figure 5
Hex Nuts
Cupped
Washers
Hex Head
Cap Screws
Figure 6

ATTACHING THE SEAT

Pull out tab on seat stop and hold open while sliding
seat out of seat pivot bracket. See Figure 4. Turn the
seat around and line up plastic seat spacers with the
slots in seat pivot bracket. Slide seat in until front
seat spacer engages the seat stop. See Figure 5. To
adjust the seat refer to the adjustment section in this
manual.
NOTE:
If your seat was shipped in a box, line up
plastic seat spacers with the slots in seat pivot
bracket and slide seat in until front seat spacer
engages seat stop.
Slot

ATTACHING THE CHUTE DEFLECTOR

The chute deflector must be attached to the right
side of the deck so that it covers the chute opening.
1. Make certain deck is raised to its highest
position (lift lever pulled all the way back).
NOTE:
Your mowing deck may be equipped with
an optional mulching plug. Remove the mulching
plug by removing the wing nut on top of the deck.
Grasp the mulching plug and pull out of the deck.
2. Remove the hex head cap screws, cupped
washers and hex nuts which are attached to the
deck next to the chute opening.
3. Place the chute deflector in position as shown in
Figure 6. Secure with hardware just removed.
Cupped sides of washers go against the chute
deflector.
9
WARNING:
Before operating your unit,
stand behind quick adjustment seat and
pull back on seat, making sure seat is
engaged in seat stop.
WARNING:
Do not operate your unit
unless the chute deflector has been
properly installed.