Table of Contents
Advertisement
Operator's Manual
Model LT-2150 Shown
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
Warning:
This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered,
brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or
state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California
the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws
apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the
service department, P.O. Box 361131 Cleveland, Ohio 44136-9722.
WHITE OUTDOOR PRODUCTS COMPANY P.O. BOX 361131 CLEVELAND, OHIO 44136-9722
PRINTED IN U.S.A.
Hydrostatic Lawn Tractor
Models LT-1650
LT-1850
LT-2150
FORM NO. 770-10314A.fm
(11/2000)
Advertisement
Table of Contents
Related Manuals for White Outdoor LT-1650
Summary of Contents for White Outdoor LT-1650
- Page 1 A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-9722. WHITE OUTDOOR PRODUCTS COMPANY P.O. BOX 361131 CLEVELAND, OHIO 44136-9722 FORM NO. 770-10314A.fm (11/2000) PRINTED IN U.S.A.
-
Page 2: Table Of Contents
Before you start assembling your new equipment, please locate the model plate on the equipment and copy the information from it in the space provided below. The information on the model plate is very important if you need help from your White Outdoor dealer. •... -
Page 3: Important Safe Operation Practices
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. -
Page 4: Slope Operation
Contact your 3. Do not try to stabilize the machine by putting your White Outdoor dealer for assistance. foot on the ground. 4. Do not use a grass catcher on steep slopes. - Page 5 Use only an approved gasoline container. by an authorized White Outdoor Products dealer. b. Never fill containers inside a vehicle or on a 4. Check brake operation frequently as it is subjected truck or trailer bed with a plastic liner.
- Page 6 manufacturer’s (O.E.M.) blade(s) only, listed in this cover are subject to wear and damage which could manual. “Use of parts which do not meet the expose moving parts or allow objects to be thrown. original equipment specifications may lead to For safety protection, frequently check components improper performance and compromise safety!”...
-
Page 7: Slope Gauge
SECTION 2: SLOPE GAUGE... -
Page 8: Tractor Set-Up
SECTION 3: TRACTOR SET-UP Attaching the Battery Cables Service the engine with gasoline and oil as instructed in the separate Briggs & Stratton Operator/Owner Manual packed with your tractor. Read instructions carefully. NOTE: The positive battery terminal is marked Pos. (+). -
Page 9: Know Your Lawn Tractor
SECTION 4: KNOW YOUR LAWN TRACTOR † ‡ NOTE: Steering Wheel not shown for clarity. PTO (Power Take-off) Lever (†LT-1650) G Cruise Control Button PTO (Power Take-off) Knob (‡LT-1850 & LT-2150) H Ignition Switch Systems Indicator Monitor/Hour Meter Brake Pedal... -
Page 10: Throttle Control Lever
19 of this manual for the proper battery charging procedure or have the engine’s charging system checked by a White Outdoor dealer. Start The hour meter operates whenever the engine is running and records the actual hours of tractor Figure 4 operation. -
Page 11: Choke Control
Refer to Starting The Engine on page 13 of this manual for detailed starting On model LT-1650, the PTO lever is located on the left instructions. side of the dashboard next to the steering wheel. Move... -
Page 12: Operating Your Lawn Tractor
• DO NOT MOW WHEN CHILDREN OR OTHERS ARE AROUND. Contact a White Outdoor dealer. The safety interlock • NEVER CARRY CHILDREN, EVEN WITH BLADES OFF. • LOOK DOWN AND BEHIND BEFORE AND WHILE BACKING. -
Page 13: Starting The Engine
Starting the Engine • Briefly depress the brake pedal to release the parking brake. Move the throttle lever into the FAST (rabbit) position. Do not operate the tractor if the WARNING: • To travel FORWARD, slowly depress the upper interlock system is malfunctioning. This portion of the drive pedal forward until the desired system was designed for your safety and speed is achieved. - Page 14 Move the throttle control lever to the FAST (rabbit) position. • Depress the brake pedal to disengage the cruise control and stop the tractor. Model LT-1650 • Lightly depress the drive pedal. • Grasp the PTO lever and pivot it all the way forward To change the direction of travel toreverse when into the engaged (ON) position.
-
Page 15: Operating The Headlights
The engine (on model LT-1650) or electric This tractor is equipped with one of White Outdoor’s IMPORTANT: PTO clutch (on models LT-1850 & LT-2150) will high quality cutting decks. The following information will automatically shut off if the PTO is engaged with the be helpful when using the cutting deck with your tractor. -
Page 16: Seat Adjustment
• Determine the approximate distance necessary for • Measure the distance from the outside of the left proper adjustment and proceed, if necessary, to the blade tip to the ground and the distance from the next step. outside of the right blade tip to the ground. Both •... -
Page 17: Maintaining Your Lawn Tractor
• Looking at the transmission from the right side of Hex Nut and the tractor, locate the compression spring and Pivot Bar Lock Washer brake disc. See Figure 10. Crown Nut Axle Brake Disc Drag Link Jam Nut Ball Joint Hydrostatic Figure 11 Transmission... -
Page 18: Service
Engine • Refill the engine with new motor oil. Refer to the Briggs & Stratton Operator/ IMPORTANT: Refer to the Briggs & Stratton Operator/Owner Owner Manual packed with your unit for information Manual for engine maintenance instructions. regarding the proper weight of motor oil. Check engine oil level before each use as instructed in Air Cleaner the Briggs &... -
Page 19: Cutting Blades
Cutting Blades Blade Separation Be sure to shut the engine off, WARNING: remove ignition key, disconnect the spark plug wire(s) and ground against the engine to prevent unintended starting before removing the cutting blade(s) for sharpening or replacement. Protect your hands by using Worn Blade Edge heavy gloves or a rag to grasp the cutting Wind Wing... -
Page 20: Changing Deck Belt & Pto Belt
(non-OEM) V-belt can be dangerous by not • On model LT-1650, remove the PTO belt from disengaging completely. For a proper working machine, around the cutting deck’s center pulley. Refer to use factory approved belts. -
Page 21: Changing Transmission Drive Belt
Model LT-1650 Engine Pulley PTO Idler Bracket (mounted on tractor) Deck belt (Bottom) Left Hand Pulley PTO belt (Top) Right Hand Pulley (beneath belt guard) Deck Idler Pulley Center Pulley Self-Tapping Screws NOTE: Left hand belt cover not shown for clarity. - Page 22 PTO clutch or engine pulley. If you don’t, see your White Outdoor dealer to have the • On units equipped with an electric PTO, the engine belt changed.
-
Page 23: Off-Season Storage
Hydrostatic Transmission The hydrostatic transmission is sealed at the factory and is maintenance free. The fluid level cannot be checked nor can the oil be changed. Always keep the area around the transmission cooling fan free of grass and debris at all times. SECTION 9: OFF-SEASON STORAGE Clean and lubricate the tractor as instructed in Section 7: Follow the instructions in the Service, Storage &... -
Page 24: Attachments & Accessories
LT-2150. See the your White Outdoor dealer for information regarding price and availability. NOTE: Lawn tractor models LT-1650, LT-1850 and LT-2150 are NOT designed for use with any type of ground- engaging attachments (e.g. tiller or plow). Use of this type of equipment WILL void the tractor’s warranty. -
Page 25: Parts List
SECTION 12: PARTS LIST (for throttle) (for starter cable) (for choke) (deflector must face forward) NOTE: Engine accessory parts are applicable to both model LT-1650 and LT-1850 & LT-2150 except where otherwise noted. REF. PART REF. PART DESCRIPTION DESCRIPTION 710-0148 Self-tapping Screw, #8-32 x .375... - Page 26 Models LT-1650, LT-1850 & LT-2150...
- Page 27 Models LT-1650, LT-1850 & LT-2150 REF. PART DESCRIPTION 710-3015 Hex Cap Screw, 1/4-20 x .75 710-0599 Self-tapping Screw, 1/4-20 x .5 712-3006 Hex Nut, 1/4-20 710-0895 Self-tapping Screw, 1/4-15 x .75 710-0924 Pan Phillips Screw, 1/4-20 x .75 710-0528 Hex Cap Screw, 5/16-18 x 1.25...
- Page 28 Models LT-1650, LT-1850 & LT-2150...
- Page 29 Models LT-1650, LT-1850 & LT-2150 REF. PART DESCRIPTION 747-1130A Deck Stabilizer Rod 683-0197 Lift Shaft Assembly 711-0332 Clevis Pin, .5 x .78 712-0206 Hex Nut, 1/2-13 712-0431 Flange Lock Nut, 3/8-16 712-3004A Flange Lock Nut, 5/16-18 712-3083 Hex Nut, 1/2-13...
- Page 30 Models LT-1650, LT-1850 & LT-2150...
- Page 31 LH Axle Assembly, .625/.750 Dia. (LT-1850/2150) 638-0020 RH Axle Assembly, .625 Dia. (LT-1650) 638-0022 RH Axle Assembly, .625/.750 Dia. (LT-1850/2150) 719-0399B Cast Iron Pivot Bar w/ Fittings, .625 (LT-1650) 719-0525B Cast Iron Pivot Bar w/ Fittings, .750 (LT-1850/2150) 712-0431 Flange Lock Nut, 3/8-16 714-0470...
- Page 32 Models LT-1650, LT-1850 & LT-2150 75 18 Attach Spring Ref. 32...
- Page 33 Models LT-1650, LT-1850 & LT-2150 REF. PART REF. PART DESCRIPTION DESCRIPTION 17840 Transaxle Mounting Bracket 756-0116 V-idler Pulley, 3.06 618-0319 Hydrostatic Transmission 756-0981A Flat Idler Pulley, 2.75 629-0949A Reverse Wire Harness Adapter & Ground 756-1166 Input Pulley, 5.0 783-0780A Neutral Return Bracket...
- Page 34 Models LT-1650, LT-1850 & LT-2150 Models Model LT-1850 LT-1650 LT-2150...
- Page 35 Models LT-1650, LT-1850 & LT-2150 REF. PART REF. PART DESCRIPTION DESCRIPTION 736-0407 Bell Washer, .45 x 1.0 x .062 647-0046A PTO Engage Lever Assembly 683-0450 PTO Engage Plate Assembly 712-0459 Flange Lock Nut, 7/16-20 710-0276 Carriage Screw, 5/16-18 x 1.00...
- Page 36 Model LT-1650...
- Page 37 Model LT-1650 REF. PART DESCRIPTION 16606 Retainer Hook 618-0574 Spindle Assembly, 5.75 Dia. w/ Fitting 756-0980 Pulley Only 683-0198D 42-inch Deck Shell 683-0254 Deck Adjustment Bracket Assembly 736-0140 Flat Washer, .385 x .62 x .063 710-0520 Hex Cap Screw, 1/4-20 x 1.5 710-0528 Hex Cap Screw, 5/16-18 x 1.25...
- Page 38 Models LT-1850 & LT-2150...
- Page 39 Models LT-1850 & LT-2150 REF. PART DESCRIPTION 16606 Retainer Hook 17982 Spindle Reinforcement Plate 618-0430A Spindle Assembly, 5.0 Dia. w/ Fitting 756-1187 Pulley Only 618-0431 Double Pulley Spindle Assembly w/ Fitting 756-0603 Pulley Only 683-0254 Deck Adjustment Bracket Assembly 683-0265C 46-inch Deck Shell 710-0167 Carriage Screw, 1/4-20 x .50...
- Page 40 Models LT-1650, LT-1850 & LT-2150...
- Page 41 NOTES...
- Page 42 NOTES...
- Page 43 NOTES...
- Page 44 Products Co. with respect to new merchandise pur- d. White Outdoor Co. does not extend any warranty for chased and used in the United States, its possessions and products sold or exported outside of the United States territories.