Auxiliary Controls - Chauvet Stage Designer 50 TFX-48B User Manual

AUXI L I ARY CO NT RO L S
This is the process of assigning the Auxiliary controls. These will act as shortcuts and are most
commonly used for DMX strobe lights or DMX fog machines. However, they are not limited to these
functions, such as Pan/tilt control-very useful for remote followspot controls.
Action 
1) Press & hold RECORD & tap the Flash
button 7 or 8 (3) times. The display should
indicate activation of the mode.
2) There are 3 functions. FUNC 1 states that
the Auxiliary control is not assigned to any
channel. FUNC 2 refers o the auxiliary
controls working much like the channel
fader along with the flash buttons. FUNC 3
is somewhat different. The rotary knob acts
to set the total output of the flash button
below it.
3) While holding down the RECORD button,
select the function you wish for the auxiliary
control by pressing Flash button 1, 2, or 3.
Release the buttons.
4) To assign the auxiliary to a channel, press
the Flash button for the channel you wish to
assign the auxiliary control to. This sets the
channel assignment. The corresponding
Led above the channel will light, indicating
that the channel has ben assigned.
5) Record exit.
Stage Designer™ 50 User Manual

Notes
You may refer to the display for the functions being
edited.
Press 7 (3) times for AUX 1 patching, and 8 (3) times
for AUX 2 patching.
While assigning an auxiliary to mode 2, the Fader for
that channel will not function. It will act as moving
the channel.
While assigning an auxiliary to mode 3, the channel
fader and the auxiliary controls will both work for
that channel on an HTP (highest takes precedent)
operating principle.
15
Revised: 2008-08-25 16:16:53