Playback; Playing A Scene; Playing A Scene To Audiotriggering - Chauvet Stage Designer 50 TFX-48B User Manual

5. Playback

This controller uses the Channel Faders and Channel Flash buttons for multiple uses. In this
occurrence, Channel Faders 13-24 (37-48) are used for the playing back of Scenes already recorded.
This is only when the controller is in the Chase◄►Scene mode. In this instance, Master Fader A
will control the manual fader controls, while Master Fader B will control the Scenes being played
back.
PL AYI NG A SCENE
A Scene can contain 1,000 steps. The term steps and scenes are used interchangeably.
Action 
1)
2)
3)
4)
5)
PL AYI NG A SCENE T O AUDI O T RIG G ERI NG
Action 
1) Select your Scene as described in the
above section.
2) Tap the Audio button until its LED lights,
indicating AUDIO mode is active.
3) Use the Audio Level slider to adjust the
sensitivity.
4) To return to normal mode, tap the Audio
button a second time, causing its LED to go
out. AUDIO mode is disengaged.
Stage Designer™ 50 User Manual
Tap the Mode Select button to select
Chase◄►Scene mode.
Tap the Page button to select the
correct page the program you wish to
run is located.
Push master Slider B to its maximum
position (fully down).
Move the desired Channel slider (13-
24) to its maximum, and the Scene will
fade in depending upon current fade
time.
Move the channel slider to adjust the
output of the current program.
13

Notes
The current mode is indicated by the 3 LEDs. Red is
the Chase◄►Scene. Yellow is 2-scene preset A/B.
And, Green is 1-24 single mode.
You may press and hold down the relevant Flash
button for the Scene to trigger the button
momentarily.

Notes
This is the process of using the built-in microphone,
or using the audio jack located on the rear of the
controller to use an alternative audio source for
triggering of the Scenes.
Revised: 2008-08-25 16:16:53