Table of Contents
Advertisement
DEL ET E A ST EP O R ST E PS
Action
1)
Enter the EDIT mode.
2)
Tap the Step button to scroll to the step you
wish to delete.
3)
Tap the Delete button when you reach the
step you wish to delete. All LEDs will light,
indicating the deletion of the step.
4)
Repeat steps 2 and 3 until all of the
unwanted steps have been deleted.
5)
Press and hold the Record & Rec Exit
button. The Scene button LED will turn off,
indicating that the Edit mode has been
exited.
I NSERT A ST EP O R ST EPS
Action
1)
Record a scene or scenes you wish to
insert.
2)
Be sure you are in Chase◄►Scene and
enter the EDIT mode.
3)
Tap the Step button to scroll to the step
which you wish to insert the step before.
You may read the step from the display.
4)
Tap the Insert button to insert the step
you've created before.
5)
Exit EDIT mode.
MO DI F Y A ST EP O R ST EPS
Action
1)
Enter EDIT mode.
2)
Press and hold the Up button if you want to
raise the intensity. Press the Down button if
you want to lower the intensity.
3)
Tap the Step button to scroll to the step
which you wish to insert the step before.
You may read the step from the display.
4)
While holding the Up or Down button, tap
the Flash button corresponding to the DMX
channel of the Scene you wish to modify
until you reach the desired intensity value
read from the display. Then, you may tap
the Flash buttons until you are satisfied with
the new Scene.
5)
Repeat steps 2, 3, and 4 until all the steps
have been modified.
6)
Exit EDIT mode.
Stage Designer™ 50 User Manual
Notes
Notes
Part of entering the Edit mode is selecting which
scene you wish to Edit. See section on Edit enable for
further instructions.
All LEDs will flash to indicate a successful Insert of
the step.
Notes
Part of entering the Edit mode is selecting which
scene you wish to Edit. See section on Edit enable for
further instructions.
All LEDs will flash to indicate a successful Insert of
the step.
12
Revised: 2008-08-25 16:16:53
Advertisement
Table of Contents
Troubleshooting
