Playing A Scene With The Speed Slider; Plating A Scene With The Standard Beat; Change The Speed Mode Between 5 & 10 Minutes - Chauvet Stage Designer 50 TFX-48B User Manual

PL AYI NG A SCENE WI T H T HE SPEED SL I DER
Action 
1) Select your Scene as described in the
above sections.
2) Move the Speed slider to SHOW MODE
position (fully down).
3) Press and hold the Rec Speed button & tap
the corresponding Flash button (13-24). The
Scene tapped will no longer run with the
standard beat.
4) Now, you may move the Speed slider to
select your desired speed.
PL AYI NG A SCENE WI T H T HE ST ANDAR D BEAT
Action 
1) Tap the Mode select button to select
Chase◄►Scene mode.
2) Tap the Park button to select Mix Chase
mode. The LED lights, indicating the
selection.
3) Select your Scene as described in the
previous sections.
4) Move the Speed slider until the display
reads your desired value.
5) Press and hold Rec Speed button & tap the
Flash button (13-24) to store the Scene.
The Scene will now run with the set time or
beat when engaged.
6) Repeat steps 4 & 5 to set a new beat time.
CH ANG E T HE SPEED MO D E BET WEEN 5 & 10 MI N UT ES
Action 
1) Press and hold the Record button.
2) Tap the Flash button 5 or 10 () times while
holding down the Record button.
3) The 5min or 10min Led should light,
indicating the Speed the slider is set to run.
Stage Designer™ 50 User Manual

Notes
Be sure AUDIO mode is disengaged.
Step #3 is not necessary if the selected Scene is not
recorded with the Standard beat.

Notes
Be sure AUDIO mode is disengaged.
As an alternative to using the Speed slider to input the
speed, you may use the Tapsync button (2) times to
define your beat.

Notes
14
Revised: 2008-08-25 16:16:53