Lowrance GlobalMap 6500C Operation Instructions Manual page 31

NOTE:
Throughout this manual, we will use the term MMC, but just re-
member your unit can use an MMC or SDC to store data.
Both of these solid-state flash memory devices are about the size of a
postage stamp. A SD card is slightly thicker than a MMC. MMCs are
available in storage capacities of 8 MB, 16 MB, 32 MB, 64 MB and
higher. SD cards are available in capacities of 8 MB, 16 MB, 32 MB, 64
MB, 128 MB, 256 MB and 1 GB.
Additional MMC cards are available from LEI Extras; see ordering in-
formation inside the back cover of this manual. MMCs and SD cards
are also available at many camera and consumer electronics stores.
In the GlobalMap 6500 and GlobalMap 6600, the MMC drawer is lo-
cated on the front of the case. To install an MMC, twist the drawer re-
tainer counter-clockwise and pull. The drawer will come out of the unit.
Place the MMC in the drawer face down (see following figures.)
Memory card drawer on the GlobalMap 6500 and GlobalMap 6600.
Slide the drawer back into the unit and twist the retainer clockwise.
The MMC is now ready for use.
In the GlobalMap 7500 and GlobalMap 7600, the two MMC slots are
located in compartments on the front of the case. The water-proof com-
partment doors are located at the lower right corner. The following fig-
ure shows a close-up of one compartment with the door opened.
Insert cards face down
Drawer
retainer
23