Complete Installation - KitchenAid KFDD500ESS Installation Instructions Manual

If Burners Do Not Light Properly:
■
Tap the "Off" pad for the cooktop control.
■ Check that the range is plugged in and the circuit breaker has
not tripped or the household fuse has not blown.
■
Check that the gas shutoff valve is set to the "open" position.
■
Check that burner caps are properly positioned on burner
bases.
Repeat start-up. If a burner does not light at this point, tap the
"Off" pad for the cooktop control and contact your dealer or
authorized service company for assistance.
Adjust Flame Height
Adjust the height of top burner flames. The cooktop "low" burner
flame should be a steady blue flame approximately ³⁄₈" (9.5 mm)
high.
A
B
A. Low flame
B. High flame
To Adjust Standard Burners:
The flame can be adjusted using the adjustment screw in the
center of the valve stem. The valve stem is located directly
underneath the control knob.
If the "Low" Flame Needs to be Adjusted:
1. Light 1 burner and turn to lowest setting.
2. Remove the control knob.
Hold the knob stem in the low position using a pair of pliers. Use
an ¹⁄₈" (3.0 mm) flat-blade screwdriver to turn the screw located in
the center of the control knob stem until the flame is the proper
size.
3. Replace the control knob.
4. Test the flame by turning the control from "LO" to "HI,"
checking the flame at each setting.
5. Repeat above steps for each burner.
12

Complete Installation

1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check that the range is level. See the "Level Range" section.
5. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth. For more information, see
the "Range Care" section of the Use and Care Guide or the
User Instructions.
6. Read "Range Use" in the Use and Care Guide or the User
Instructions.
7. Turn on surface burners and oven. See the Use and Care
Guide or the User Instructions for specific instruction on
range operation.
If Range Does Not Operate, Check the Following:
■ Household fuse is intact and tight, or circuit breaker has not
tripped.
■ Range is plugged into a properly grounded outlet.
■ Electrical supply is connected.
■ See "Troubleshooting" or "Problem Solver" in the Use and
Care Guide or the User Instructions.
If You Need Assistance or Service:
Please reference the "Warranty" section of the Use and Care
Guide or the User Instructions.