Safety Equipment And Labels - Shindaiwa HT230 Owner's/Operator's Manual

Safety Equipment and Labels

WARNING
Use caution to
avoid misassembly
Assemble as
per illustration
Caution Label
p/n 19402-00110
Cover
Caution, Danger, Warning, and Operation Information Labels:
Make sure all information labels are undamaged and readable.
Immediately replace damaged or missing information labels.
New labels are available from your local authorized Shindaiwa
dealer.
6
Caution Label p/n 19402-00144
HT2301
ON-OFF
Switch
Throttle
Lockout
Troubleshooting Guide (continued)
LOW POWER OUTPUT
What To Check Possible Cause
Operator is overworking
Is the engine
the unit.
overheating?
Carburetor mixture is
too lean.
Improper fuel/oil ratio.
Fan, fan cover, cylinder
fins dirty or damaged.
Carbon deposits on the
piston or in the muffler.
Clogged air filter.
Engine is rough
at all speeds.
Loose or damaged
May also have
spark plug.
black smoke
and/or unburned
fuel at the
exhaust.
Air leakage or clogged
fuel line.
Water in the fuel.
Piston seizure.
Faulty carburetor and/or
diaphragm.
Overheating condition.
Engine is
knocking.
Improper fuel.
Carbon deposits in the
combustion chamber.
Remedy
Cut at a slower rate.
Consult with an authorized
servicing dealer.
Refill with clean fresh unleaded
gasoline with a pump octane of
87 or higher, mixed with
Shindaiwa Premium 2-cycle
mixing oil at a 50:1 gasoline/
oil ratio.
Clean, repair, or replace
as necessary.
Consult with an authorized
servicing dealer.
Clean or replace the filter.
Tighten or replace the plug with
a Champion CJ8 or equivalent
type spark plug of the correct
heat range. For EMC compliance,
use NGK BMR6A Re-start.
Repair or replace
filter and/or fuel line.
Refill with fresh fuel mixture.
See page 9.
Consult with an authorized
servicing dealer.
Consult with an authorized
servicing dealer.
See above.
Check fuel octane rating;
check for presence of alcohol
in the fuel. Refuel as necessary.
See page 9.
Consult with an authorized
servicing dealer.
19