Belt Adjustment - Meccanica Benassi TR 50 User Manual

It is possible to adjust the tension of wheels transmission belt (Part. "A" pic. 2) and of blade shaft (Part. "B" pic.
2). To do this, act on the adjuster "A" on the lever (pic. 3 pag. 5 and part. A- pic.6 pag.6). If this is not enough,
keep the hood away (Part. "C" pic. 1) and move the engine ahead and back using slots placed on the engine support
itself (Part, "A" Pic.3) to reach a right belt tension.
Pic. 1
TR60
TR80
Pic. 2
TR50
TR60
TR80
BLADE-SHAFT BRAKE ADJUSTMENT
In order to adjust the blade-shaft brake ( Part. A), remove the hood and unscrew the nut (Part. B) placed on the brake
tie-rod (Part. C). Screw or unscrew the brake-tie "C" till when lever "C" (Pic.6 Pag.6) is UP and the brake-pad
touches the pulley. Block nut (Part. "B") again after this adjustment.

BELT ADJUSTMENT

IMPORTANT!
Pic. 1
TR50
Pic. 3
TR50
TR60
TR80
IMPORTANT!
- 9 -