Meccanica Benassi TR 50 User Manual page 8

TR50-TR60: To unlock wheels pull lever B placed on the right
side of handlebar (Pic. 4 ).
TR80: To unlock left wheel, pull lever D (Pic. 5);
To unlock right wheel, pull lever B (Pic. 4).
In a standard use, when lever A is free (Pic.5 Pag. 6) and lever B
(Pic.6 Pag. 6) is down, any speed working, wheels are always
automatically braked. In an emergency the braking system is the
same.
TR80: left lever B (Pic.6 Pag. 6) and right lever B (Pic.6 Pag. 7)
must be both down.
ATTENTION ! on slopes don't use the disengagement lever B
(Pic.6 Pag. 6). Its use makes wheels free and the machine
becomes without control even with a speed put into a gear.
Releasing this lever (on right in TR50 and TR60, and on right
and left on TR80) the machine is automatically in a safety condition.
Lever "C" is used for starting the blade shaft (Pic.4).
Lever "C" UP means blade's brake is engaged (Pic. 4).
Lever "C" DOWN means blade shaft is working (Pic.4).
N.B. Attention!!! For the engagement of the blade shaft, put the
machine on a clean ground, keep block D away and lower lever
"C" slowly in order to avoid that engine stops (Pic.8 Page 6).
IMPORTANT!
Move always the lever "A" when the engine is in
the lowest speed and with the left engagement
lever in position UP (Part."A" Pic.3-4 Pag.7)
Anyway, never force when moving the A lever.
TR50: 1 speed forward only.
TR60-TR80: 2 forward speeds and 1 reverse.
Pic. 5
TR60
TR80
SPEEDS CONTROL LEVER
7
Pic. 3
TR50
Pic. 4
TR50
TR60
TR80