Main function of lever "1" is the engine to
be stopped when handlebars are left away.
Do not tie the engine stop lever "1" to the
handlebar handle..
Each time the engine is started, check that
the safety clutch "3" is into lever "2".
ENGINE STOP: lever "1" up.
ENGINE RUNNING: lever "1" down.
Often check that tyre pressure be within the limits of 1 – 1,2 Bar .
CLUTCH: Check the idle stroke of the
clutch lever regularly. This should be
approximately 5mm
•
In order to change adjustment , loosen
nut 5.
•
Set stroke to about 5mm by screwing or
unscrewing adjuster 4.
•
Lock nut 4 again..
POWER TAKE OFF CONTROL LEVER:
Periodically check the idle stroke of lever 8.
To change adjustment
screw or unscrew adjuster 7. Then lock nut 6
again.
15 – ENGINE STOP SAFETY DEVICE
16 – TYRE PRESSURE
17 - CONTROLS ADJUSTMENT
loosen nut 6 and
BEFORE USING THE MACHINE IT IS IMPORTANT TO
VERIFY WITH CLOSE ATTENTION THAT SAFETY
DEVICES ARE ALL WELL WORKING.
4
8
- 8 -
1
3
2
6
5
7