Table of Contents
Advertisement
Wireless Remote Controller Kit
10
Address Setting
When two or more indoor units controlled by the same wireless remote controller are
installed in a room, a unique address can be set for each indoor unit to prevent
interference.
Up to 6 indoor units can be controlled independently by the remote controller by
matching the address switch setting of the signal receiving part with the address
displayed on the remote controller. The signal receiving part (inside the ceiling panel
or indoor unit) has address switches for receiving addresses, and the remote
controller has an address button for transmitting addresses.
For details, contact the dealer from whom you purchased the air conditioner.
Checking Addresses
Push
on the remote controller. The current address appears on the display.
ADR
When this address equals the address of the address switch in the signal receiving part
(inside the ceiling panel or indoor unit), the buzzer sounds. When the address on the display
is "ALL," the buzzer sounds and the remote controller is enabled regardless of the address
switch setting in the signal receiving part.
Transmit signals while pointing the remote controller at the signal receiving part of the indoor
unit to be controlled.
Matching Addresses
Address setting on the remote controller
1. Push
for at least 4 seconds. "Address" lights up on the display and the current address flashes.
ADR
2. Each time you push
an address that matches the address switch setting in the signal receiving part of the indoor unit to
be controlled.
3. Push
. The flashing address changes to lighting and is displayed for 5 seconds. When this
address equals the address switch setting in the signal receiving part, the buzzer sounds.
Address displayed on
the remote controller
(The location of
ADR
is
shown on page 3.)
Address switch setting
in the signal receiving
part (inside the ceiling
panel or indoor unit)
, addresses change cyclically like ALL → 1 → 2 → 3...→ 6 → ALL. Select
ADR
Address
Address
* Any setting is
OK.
Set S001 to the right position (for addresses 1, 2, and 3) or to the left
position (for addresses 4, 5, and 6).
Set S002 to the right position (for addresses 1 and 4), to the center (for
addresses 2 and 5), or to the left position (for addresses 3 and 6).
Address
– 12 –
Owner's Manual
EN
Address
12-EN
Advertisement
Table of Contents
