Remote Access Code; Message Alert Tone - AT&T CL83143 Abridged User Manual

Answering system
Answering system settings

Remote access code

To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press MENU/
enter the main menu.
2. Press q or p
CID
3. Press q or p
CID
4. Press q or p
CID
5. Use the dialing keys to enter a
handset or X/DELETE on the telephone base to backspace and delete a digit.
6. Press /SELECT to save the setting.
MENU

Message alert tone

When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every ten seconds.
alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press MENU/
the main menu.
2. Press q or p
CID
3. Press q or p
CID
4. Press q or p
CID
5. Press q or p
CID
6. Press /SELECT to save the setting.
MENU
to scroll to Answering sys, then press
DIR
to scroll to Ans sys setup, then press
DIR
to scroll to Remote code, then press
DIR
two-digit number. Press
to scroll to Answering sys, then press
DIR
to scroll to Ans sys setup, then press
DIR
to scroll to Msg alert tone, then press
DIR
to choose On or Off.
DIR
42
SELECT
/SELECT.
MENU
/SELECT.
MENU
/SELECT.
MENU
/DELETE on the
MUTE
By default, the message
SELECT
/SELECT.
MENU
/SELECT.
MENU
/SELECT.
MENU
to
to enter