Table of Contents
Advertisement
Chapter 3
Verify Installation
Hardware
Check the status of the LEDs on the Interface cards and backplane to verify good connection or link between your host
computer and expansion unit.
1.
Thunderbolt™ 1 interface card : 5 solid green LEDS are illuminated and three solid green LEDs on the backplane. For
more details see "Thunderbolt™ 1 Interface Card LEDs" below.
2.
Thunderbolt™ 2 Interface Card: 7 solid green LEDs are illuminated and 3 solid green LEDs on the backplane. For more
details go to "Thunderbolt™ 2 Interface Card LEDs on page 20".
Thunderbolt™ 1 Interface Card & LEDs
When the Thunderbolt™ 1 Interface card is fully operational and with an external Display device attached, 5 green LEDs are
illuminated (solid green), see FIGURE T1-A .
IMPORTANT
If you are only seeing Two Green LEDs that are illuminated on the Thunderbolt Interface card after the
Magma Roben-3 is turned on, this indicates that there a hardware failure within your expansion unit. Check
your Thunderbolt cable, make sure it is connected firmly and the Thunderbolt Interface card is seated in the
PCIE slot properly.
FIGURE T1-A
ExpressBox 3T | Chapter 3
Magma
Verify Installation
15
Advertisement
Table of Contents
