Care And Maintenance - Shark SK410 series Owner's Manual

Using Your Steam & Spray
- cont'd
Frequently Asked Questions
Q. My Steam & Spray Mop leaves a foam on hard
™
floors.
A. The Steam & Spray Mop
Pad is likely too saturated. Replace it with a
clean, dry pad.
Q. My floors appear cloudy after cleaning.
A. The Steam & Spray
dirty. Change the pad.
A. The Steam & Spray
washed with a powder detergent and may be
damaged and require replacement. Never use
powder detergents. Only use liquid detergent to
launder the cleaning pads.
A. The Steam & Spray
the same spot for too long with a wet cleaning
pad. Never leave the unit with a wet pad in one
spot for too long.
A. This may be leftover from past cleaners that
were used on the floor surface. Use the Steam
& Spray Mop a few more times and see if the
™
leftover cloudiness is removed. If this does not
work, we suggest rinsing the floor with water
and letting it dry. One or more rinses generally
removes the residue. A more stubborn case may
require you to rinse the floor with a mix of one
part vinegar to 2 parts water. Then use the Steam
& Spray Mop again with a clean pad.
™
General Tips:
• Change the Cleaning Pad frequently for best results.
• Always vacuum floors before cleaning or polishing.
• Use both cord clips to keep plug securely in place
while in use.
• To remove or replace Steam Energized™ Cleanser,
simply twist and lift upward.
• Ensure the water tank is filled at all times.
6
1-800-798-7398
Mop
™
Washable Cleaning
™
Mop Cleaning Pad may be
™
OR
Mop Cleaning Pad was
™
OR
Mop may have been left in
™
OR

Care and Maintenance

fig. 15
AFTER USE AND STORAGE
1 When you have finished using the Shark
& Spray Mop, turn the steam locking collar to
™
the "Spray Only" position. This stops the unit from
steaming. Unplug the cord from the electrical outlet
and remove the Cleaning Pad from the unit.
2 S tore the Shark Professional Steam & Spray
®
Mop in the upright position without the Cleaning
Pad on the unit and away from children or in high
traffic areas.
3 Wrap the power cord around the cord holders when
not in use. (Fig. 15)
CLEANING THE SPRAY NOZZLE
1 If the spray nozzle becomes clogged, you can clean
it by removing it from the mop head. To remove it,
place a flat screwdriver underneath the nozzle and
lift up. The nozzle will pop off. Run the spray nozzle
under warm water to clean it out. Reinsert the spray
nozzle by lining up its grooves with the inside of the
nozzle hole. Push it in until it snaps into place.
(Fig. 16)
DECALCIFYING YOUR STEAM MOP
Calcium and mineral deposits can build up and impact
the performance of your steam mop over time. To
extend the life of your product we recommend that you
use distilled water or Shark
Visit www.SharkClean.com to order.
fig. 16
Steam
®
™
's Water Filtration Bottle.
®