Shark SK410 series Owner's Manual page 17

PROBLEM
Shark Steam & Spray
®
Mop leaves water on the
floor.
Floors are cloudy, spotty or
streaky after cleaning.
Shark Steam & Spray
®
Mop is hard to push.
HOW TO REMOVE THE HANDLE
(Not for storage purposes, for return only)
1 Locate the release button behind the cord wrap in
the body of the mop.
2 Use a screwdriver to press the release button.
(Fig. 18)
3 Pull up on handle to remove from body of the mop.
POSSIBLE REASONS & SOLUTIONS
1. Do not leave the Steam & Spray
™
2. If you are using tap water, we recommend switching to distilled water.
3. Make sure that the cap is securely placed on the water tank.
1. The cleaning pad may be dirty. Change the cleaning pad.
2. If the washable cleaning pad was washed with powder detergent, then it may
be damaged and require replacement. Replacement pads are available at www.
sharkclean.com.
3. The mop may have been left in one spot for too long.
4. This may be leftover from past cleaners used on the floor surface. Use the mop
a few more times again with a clean pad and see if the cloudiness is removed.
If this does not work, we suggest rinsing the floor with water, letting it dry
and then steam mopping again with a clean pad. One or more rinses generally
removes the residue. A more stubborn case may require you to rinse the floor
with a mix of one part vinegar and two parts water.
1. Make sure the cleaning pad is attached correctly.
™
2. Check to see if the cleaning pad is excessively dirty. If so, replace with a clean
pad.
Mop on the floor with a damp cleaning pad.
™
fig. 18
www.sharkclean.com
9