Paprwidth Mismatch; Paper Size Not Detected - Canon iPF670 Series Basic Manual

iPF670 Series
Cause
The loaded paper is too small.
"Remove paper and check pap. size"
A sheet has come out of the printer during printing.

PaprWidth Mismatch

PaprWidth Mismatch
Cause
When Detect Mismatch in the Control Panel
menu is set to Pause, the width of the loaded roll
does not match the width specified in Fit Roll
Paper Width in the printer driver.

Paper size not detected.

Paper size not detected.
Cause
Paper has been loaded
askew, or warped paper
has been loaded.
Basic Guide
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2.
Replace the roll with a roll 10 inches wide or larger.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Cause
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing qual-
ity.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
1.
2.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded in
the printer, and then try printing again.
Follow these steps to reload the roll.
1.
Press the OK button and reload the paper.
(See "Loading Rolls in the Printer.")
2.
Pull the Release Lever forward.
Corrective Action
P.17
➔
User's Guide
➔
P.12
➔
P.14
➔
1.
Press the Release Lever back and remove the paper.
2.
Reload the sheet, aligning it with the guide on the right.
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is
shown on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the error occur-
red.
(See "Loading Sheets in the Printer.")
Corrective Action
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
Replace with paper of the width configured in the printer driver.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Corrective Action
P.14
➔
PaprWidth Mismatch
Corrective Action
P.20
➔
P.17
➔
User's Guide
➔
P.12
➔
P.14
➔
113