Panasonic Road Choice 1000-RIO160U Operating Instructions Manual page 10

General
Caution
Set the volume level to low enough before the AUX connection is completed.
Failure to observe this may generate loud noise and accordingly damage your speakers and your hearing.
[SRC] (Source)
selects a source.
[PWR] (Power)
toggles power on/o .
[MUTE]
toggles mute on/o .
[SQ] (Sound Quality)
selects a sound type
(SQ).
Power On/O
Set your car's ignition switch to the ACC or ON position.
Power on: Press [SRC] (PWR) .
Power o : Hold down [SRC] (PWR) for more than 1
second.
Source Selection
Press [SRC] to change the source.
d
d
When a device connected to the front AUX terminal of this
unit
d
(Return to "RADIO")
Volume Adjustment
(Setting Range: 0 to 40, Default: 18)
Turn [VOL] clockwise to increase the volume, and
counterclockwise to decrease the volume.
Volume level (0 to 40) (default: 18)
[VOL] (Volume)
Radio
Disc player
AUX
AUX Connector (3.5 mm ø stereo)
From line output of external sound/audio device
(ex. Silicon audio player, HDD player, etc.)
Mute
Press [MUTE] to mute the sound completely.
Press again to cancel.
SQ (Sound Quality)
SQ is a function that can call up various sound types at the
touch of button in accordance with your listening music
type.
Hold down [SQ] for more than 2 seconds to select the
sound type as follows:
Flat frequency response:
does not emphasize any part. (default)
d
Speedy and heavy sound:
exaggerates bass and treble.
d
Wide-ranged and deep sound:
slightly emphasizes bass and treble.
d
Clear sound:
emphasizes middle tone and slightly emphasizes treble.
d
(Return to "FLAT")
Note: Settings of SQ, bass and treble are influenced one
another. If such an influence causes distortion to the audio
signal, readjust bass/treble or volume.
Remote Control Sensor
(FLAT)
(ROCK)
(POP)
(VOCAL)
R
To e
tion
[SRC]
selec
[BAN
selec
(APM
execu
(by h
secon
Ope
1
Pr
2
Pr
3
Se
Freq
[6
[7
Note:
for m
Pres
Press
throu
Rad
light