X10 UR24E User Manual page 8

[18] L1 L2: Spare learn Keys. These keys are not pre-programmed and lets you learn additional
key from an original remote control
[19] Teletext Mix : Allows to mix the Teletext and the picture of the selected channel
[20] Teletext Hold : Stops page change in teletext mode
[21] VCR button Play , FF , Stop, Rew , Pause :
In VCR CD & DVD mode: These buttons work directly for the majority of the available brands
and work the same way as in your original remotes
In TV mode: Fast text function.
[22] Teletext ON, in Shift mode: turn on the menu of the selected appliance
[23] Teletext OFF, in Shift mode: turn off the menu of the selected appliance
[24] REC (record ): This key works the same way as the one on your original remote for your
VCR. In order to avoid a mistake you have to press this key twice to activate this feature.
Default Volume Control
Because some satellite decoder does not have volume control, the 8 in 1 remote can control
the television's volume in SAT mode. (No need to select TV mode). To choose the equipment
that the Mute and Volume keys will control in SAT mode, just proceed as follow :
1. Press and release the TV Mode button (5) - remote must be in TV mode for this procedure.
2. Press and hold SETUP (4) button until LED remains on.
3. Release SETUP button.
4. Press and hold the Mute (15) key for approximately 8 seconds : during this period, the
LED will stay off or 8 seconds, then blink once more to indicate volume default acceptance.
The LED will remain off. Release the Mute key.
5. Remote volume default is now set. If the 8 in 1 remote control was previously controlling
the television volume in SAT mode, it will now control the volume of the satellite decoder.
If it was previously controlling the volume of the satellite decoder, it will now control the
volume of the television.
5) Programming your TV, VCR , DVD, SAT, CD and CBL
Note : you can dedicate any appliance (TV, DVD,SAT...) to the VCR, DVD, SAT, CD, CBL
and PC keys: you need first to enter the 3 digit code of the appliance you wish to control
(found in the code book). In any case, follow the method below:
1. Press and hold the SETUP (4) key until the LED indicator lights continuously. Release
the SETUP key.
2. Press and release the mode key (5) of the device you want to control (for example TV).
3. Make sure your equipment is switched on (for example TV)
4. Enter the 3 digit code (10) from the library table. The LED (1) turns off after the last digit is
entered. If you entered a wrong code the LED blinks for 3 seconds and then goes off. You
have to repeat from step 2.
5. Point the remote in the direction of your TV and press the POWER button (2). Your device
should turn off. Check other functions (for example for a VCR: FF or REW etc.). If certain
functions are not responding this indicates that the entered code is not the correct one. In
8