X10 UR24E User Manual page 12

LED (1) will turn off.
Note for programming Macro's:
It may be necessary to have "delays" included in the Macro sequence (e.g. to allow your TV
warm-up time). Delays can be achieved by using the Pause key followed by the number of
seconds delay required e.g. to enter a delay of 4 seconds, press and release Pause followed
by 4. Maximum delay is 9 seconds. It is not possible to have a "0" digit entered after Pause
i.e. there is no zero delay.
There is an automatic delay of 1 second between each IR transmission in the sequence
To Delete a Macro :
1. Press and hold the Setup (4) button until the Visible LED remains on. Release Setup.
2. Press and release the Macro key (M1 or M2) you want to delete. The LED will blink off to
indicate the keypress acceptance.
3. Press and release the Setup key. The LED will turn off and the Macro is deleted.
12) Controlling your house with home automation modules from X10
The 8in1 remote control allows you to command all electric appliances you have in your
house. In addition to transmitting infrared signals, which control your TV, VCR, SAT, CD,
DVD and CBL, your remote is equiped with a radio transmitter sending X10 signals, which
will enable you to control from a distance lamps and electric appliances.
Here are some examples that you can do with your 8 in 1 remote using X10
- Switch on/off , dim lights while you watch TV.
- Switch on the lights at night to frighten intruders when you detect something suspicious
- Switch on your electric blanket before the film ends to have it warm when you go to sleep
For controlling your lamps or appliances, you will need additional X10 home modules. The
modules are simply plugged into a/c outlet with no additional wiring required. Contact your
retailer for additional information.
- To switch on/ off an appliance plugged into an X10 module : Press the X10 key (7), then
press the unit code of the X10 module on the key pad (10) and then press CHAN+ / - (14)
- To dim/bright a light plugged into an X10 module : press its unit code on the key pad (16)
and then press VOL+ / - (16)
- To turn ON all the X10 Lamp modules: Press the Power key (2)
- To turn Off all the X10 modules (Lamp and appliance): press the Mute key (15)
13) Changing the X10 House Code
The preset house code is A and in the majority of cases it is not necessary to change this
setting except if there is interference from neighbouring X10 systems. In that case :
1- Press X10 key (7)
2- Press and hold SETUP (4) until the LED lights continuously
12
: