X10 UR24E User Manual page 10

(you can step forward by pressing CHANNEL+(14) in case you went too far back). As
soon as the device responds again, press the ENT key (11) to store the code you found.
8) Identifying codes found using the search procedure
1. Press and hold SETUP (4) until the LED indicator (1) lights steadily. Release SETUP
2. Press the mode key (5) for the equipment you want to identify (TV, VCR, DVD, SAT, CD,
CBL). The LED blinks once.
3. Press again SETUP. The LED blinks once.
4. To identify the first digit press each number button from 0 - 9 (10) until the LED blinks. The
number you pressed is the first digit of the code.
5. Press each number key from 0 - 9 as above to find the second digit.
6. Press each number key from 0 - 9 as above to find the third digit. When the third digit has
been found the LED will go off. Don't forget to write down the code on the label of the
battery compartment.
9) Learning commands
Your 8 in 1 remote has the codes for most TVs, VCRs etc. in its code library. However, if the
code for your particular device is not found in the library, you can learn these codes from your
existing remote. Or if you find a code from the tables in this manual that "almost" matches
your device, but a few buttons are missing, you can learn just those buttons.
1. Point your existing remote at the 8 in1 remote control (front to front) with a distance of
about 2,5 centimeters between the remotes.
2. Press and hold SETUP (4) until the LED indicator lights steadily.
3. Press the MODE button (TV, CD, SAT, etc.) that matches the equipment you wish to
learn. The LED (1) blinks once.
4. Press and release the LEARN button (3) . The LED (1) blinks once.
5. Press and release the button on the 8in1 remote control which will learn the function. The
LED blinks once.
6. Press the function key on your existing remote that you want to transmit. Hold the button
until the LED on the 8 in 1 remote control blinks off shortly.
7. Repeat steps 5 and 6 for each function you want to learn.
8. When you've finished learning all the keys, press SETUP (4).
10) Clearing learned commands to free up memory
To Clear all stored Learned Commands under a Mode :
You can clear learned commands for each device individually (TV, VCR. Etc.):
1. Press and hold SETUP (4) until the LED indicator light steadily. Release the SETUP
button.
2. Press the desired mode button (TV, VCR, etc.) (5). The LED flashes once.
3. Press and release the LEARN (3) key twice.
4. Press the SETUP (4) key. The LED (1) will turn off after a few seconds.
5. All learned commands entries under that mode are now cleared.
10