Lip Sync; Zone 2 (Cxr200 Only) - CAMBRIDGE CXR120 Reference

Input Setup cont.

Lip sync

The CXR can if required apply a small delay to the audio playback to
resynchronise it to any video playback which appears to be behind the audio
in time.
This can sometimes happen if the video is slightly delayed by a player or TV
performing a lot of video processing.
Pressing the Lip Sync button on the remote will bring up the current Lip
Sync value on the CXR's main display and allow adjustments in 5mS (5
thousandths of a second) increments.
Source 1
Lip Sync:
Setting the Lip sync value to 0 causes Lip Sync delay to be turned off.
Note: The Lip sync value is stored and recalled separately for each source.

Zone 2 (CXR200 only)

CXR Setup Menu
Speaker Setup Zone 2 Power
Input Setup Zone 2 Source
Zone 2 Settings Zone 2 Power On Volume
Network Setup
General Settings
HDMI Output Setup
Advanced Setup
Note: To enable the Zone 2, go to 'Zone 2 Settings' and select On from the
available option, or press the Zone 2 and power on either from the front panel
or the remote, or use the Cambridge Connect app.
The CRX200 features a set of Zone 2 outputs which can independently
access audio/video sources connected to the unit via a range of connections.
There is also a Follow Main Zone function. If the main zone is a multichannel
audio stream then this sends a 2 channel down-mix (L+C, R+C) of the source
currently selected in the Main Zone to Zone 2, otherwise the stereo audio is
used directly.
If a different source is selected for Zone 2, then the zone 2 source must have
a stereo input audio selected. It is not possible to have separate multichannel
audio sources in both zones. The 2 channel down-mix is only available when
Zone 2 is set to Follow Main Zone.
Highlight the Zone 2 source item and use the Navigational buttons to scroll
through the sources. Whichever you select will be sent to the Zone 2 outputs.
The Zone 2 source can also be selected using the remote control.
The audio output connection are via the Zone 2 Left and Right speaker
channels and the Zone 2 Pre Out. The Zone 2 audio/video output connection
is via HDMI 2.
Zone 2 speaker connections
Firstly, enable Zone 2 speaker output by going to 'Speaker Setup > Back Amp
Configuration' and selecting 'Zone 2' from the available option.
26
-20
0 ms
On
Follow Main Zone
- 30 dB
Now connect a suitable pair of loudspeakers (8 ohms) for Zone 2 as shown
below to the Zone 2 Left and Right speaker outputs.
Zone 2
With this configuration you can now control Zone 2 from the main room by
using the Zone 2 control function on the supplied remote.
Using Zone 2 with an external stereo power amp.
The CXR Zone 2 outputs include a permanently available Zone 2 output. This
can be used to connect a separate power amp in Zone 2.
If the remote Zone 2 power amp features a trigger input to turn it on and off it
is possible to use one of the CXR trigger outputs for this. Connect a suitably
long 3.5mm mono jack 3.5mm mono jack lead from the Trigger output as
shown.
Zone 2
Zone 2