Table of Contents
Advertisement
network connection and setup
auto network Setup
Run <ip installer_v2.XX.exe> to display the camera search list.
At the initial startup, both [auto Set] and [manual Set] will be grayed out.
For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not
`
M
support this function.
1. Select a camera in the search list.
Check the MAC address of the camera
on the camera's label.
Both the [auto Set] and [manual Set]
buttons will be activated.
2. Click [auto Set].
The Auto Setting dialog appears.
The <ip address>, <Subnet mask>,
and <Gateway> will be set automatically.
3. Enter the password.
Enter the password of "admin" account,
which was used to access the camera.
For the security purposes, you are
`
J
recommended to use a combination
of numbers, alphabets uppercase and
lowercase and special characters for your
password.
If you want to change the password, refer
`
to "Administrator password change" of
the user setup. (page 87)
4. Click [oK].
Auto network setup will be completed.
62_ network connection and setup
Hide quick links:
Advertisement
Table of Contents
